AVVGz, AVVGzng, AVVGzng-LS

TU U 27.3-38456790-015:2019
Power cables with plastic insulation
AVVGz, AVVGzng, AVVGzng-LS

Aluminium core power cables (Class 1 & 2) with polyvinylchloride insulation and sheath
А Aluminium conductive core
V Polyvinylchloride plasticate insulation
V Polyvinylchloride plasticate sheath
G Unarmored (bare)
z Inter-core filler
ng Non-combustible
ng-LS Non-combustible, reduced smoke and gas release

Operating and installation requirements

  • Ambient temperature from -50°C to 50°C.
  • Relative humidity up to 98% at temperatures up to 35°C.
  • Cables can be laid without preheating at temperatures not lower than –15°C.
  • Minimum bending radius during installation should be not less than 15 outer diameters of a single core cable and 12 outer diameters of a multi-core cable.
  • Long-term temperature rise limits for cable cores should not exceed 70°C.
  • Temperature limit in the overload mode is max 90°C.
  • Rated alternating voltage up to 0.66 kV and up to 1kV.
  • Warranty service life is 5 years.
  • Service life is minimum 30 years

Wires intended use
AVVGz, AVVGzng, AVVGzng-LS

Cables are intended for transmission and distribution of electric power in permanent equipment for 0.66 kV and 1 kV nominal AC voltage and 50 Hz frequency

Used for laying in blocks, on specialised cable racks, can be utilised in industrial premises, switchgear and lighting systems, as well as in standard residential buildings as electrical wiring and in cottage construction. It is not recommended to lay this cable type in the ground as it is not armoured. Laying in trenches is only acceptable if protection against mechanical damage is applied.

Conductor design
AVVGz, AVVGzng, AVVGzng-LS

Core count Rated voltage, , kV
0,66/1
Main cores nominal cross-section, mm2
2, 3, 4 2,5 - 16 2,5 - 240
5 2,5 - 16 2,5 - 240

Design data for
AVVGz, AVVGzng, AVVGzng-LSwires

Core nominal cross-section, mm2 Nominal thickness, mm Nominal cable diameter, mm Maximum cord resistance at 20°C, Ohm/km Minimum value of insulation resistance at 20°C, MOhm/km Calculated mass of 1 km cable, kg
insulation sheath АVVGz
2х2,5 0,6 1,2 8,3 12,1 12,0 87
2х4 0,7 1,3 9,7 7,41 10,1 121
2х6 0,7 1,3 10,8 5,11 8,7 152
2х10 0,9 1,4 14,4 3,08 7,1 262
2х16 0,9 1,5 16,6 1,91 5,8 367
3х2,5 0,6 1,3 9,7 12,1 12,0 121
3х4 0,7 1,3 10,3 7,41 10,1 140
3х6 0,7 1,3 11,5 5,11 8,7 177
3х10 0,9 1,4 15,3 3,08 7,1 304
3х16 0,9 1,5 17,7 1,91 5,8 411
3х25 1,2 1,7 22,1 1,20 5,6 640
3х35 1,2 1,7 24,6 0,868 4,9 800
3х50 1,4 1,9 28,6 0,641 4,8 1077
3х70 1,4 2,0 32,7 0,443 4,1 1425
3х95 1,6 2,2 38,0 0,320 4,1 1931
3х120 1,6 2,3 41,4 0,253 3,7 2298
3х150 1,8 2,4 46,0 0,206 3,7 2843
3х185 2,0 2,6 51,3 0,164 3,7 3538
3х240 2,0 2,8 56,7 0,125 3,6 4354
4х2,5 0,6 1,2 9,6 12,1 12,0 119
4х4 0,7 1,3 11,3 7,41 10,1 168
4х6 0,7 1,3 12,6 5,11 8,7 213
4х10 0,9 1,5 16,9 3,08 7,1 366
4х16 0,9 1,6 19,6 1,91 5,8 496
4х25 1,2 1,7 24,5 1,20 5,6 778
4х35 1,2 1,8 27,3 0,868 4,9 974
4х50 1,4 2,0 31,8 0,641 4,8 1313
4х70 1,4 2,1 36,4 0,443 4,1 1741
4х95 1,6 2,3 42,4 0,320 4,1 2362
4х120 1,6 2,4 46,2 0,253 3,7 2813
4х150 1,8 2,6 51,4 0,206 3,7 3484
4х185 2,0 2,8 57,3 0,164 3,7 4338
4х240 2,0 3,0 63,2 0,125 3,6 5316
5х2,5 0,6 1,3 10,5 12,1 12,0 140
5х4 0,7 1,3 12,4 7,41 10,1 198
5х6 0,7 1,4 13,9 5,11 8,7 253
5х10 0,9 1,5 18,8 3,08 7,1 437
5х16 0,9 1,6 21,8 1,91 5,8 590
5х25 1,2 1,8 27,2 1,20 5,6 928
5х35 1,2 1,9 30,3 0,868 4,9 1164
5х50 1,4 2,1 35,4 0,641 4,8 1570
5х70 1,4 2,3 40,6 0,443 4,1 2085
5х95 1,6 2,5 47,2 0,320 4,1 2832
5х120 1,6 2,6 51,5 0,253 3,7 3376
5х150 1,8 2,8 57,3 0,206 3,7 4182
5х185 2,0 3,0 63,9 0,164 3,7 5210
5х240 2,2 3,3 71,9 0,125 3,6 6752

Note: Calculated and nominal data can deviate from the actual data.
Identification markings meet fire safety requirements under DSTU 4809:2007
AVVGz – PB 100000000
AVVGzng – PB 120000000
AVVGzng-LS – PB 123111000